Outlander 2WD V6-3.0L (6B31) (2007)
/Page-1283001.png)
Wheel Bearing: Testing and Inspection
Front Axle
WHEEL BEARING END PLAY CHECK
1. Remove the caliper assembly, and retain it with a wire and the like to prevent from falling.
2. Set a dial gauge as shown in the figure. Move the hub in the axial direction and measure the end play.
Limit: 0.05 mm (0.002 inch)
3. After checking, install the brake disc and the caliper assembly, and tighten the caliper mounting bolt to the specified torque.
Tightening torque: 100 ± 10 Nm (74 ± 7 ft-lb)
