Outlander 4WD L4-2.4L (4B12) (2008)
TROUBLE JUDGMENT CONDITIONS
If the conversation is not possible even when the steering wheel voice control switch is operated, the steering wheel voice control switch or radio and CD
changer <vehicles without MMCS> or the audio visual navigation unit <vehicles with MMCS> may be defective.
TROUBLESHOOTING HINTS
-
Malfunction of the steering wheel voice control switch
-
Malfunction of the hands free module
-
Malfunction of the radio and CD changer vehicles without MMCS> or audio visual navigation unit <vehicles with MMCS>
-
Damaged harness wires and connectors
DIAGNOSIS
Required Special Tools:
-
MB991223: Harness Set
-
MB992006: Extra Fine Probe
-
MB991958: Scan Tool (M.U.T.-III Sub Assembly)
-
MB991824: Vehicles Communication Interface (V.C.I.)
-
MB991827: M.U.T.-III USB Cable
-
MB991910: M.U.T.-III Main Harness A (Vehicles with CAN communication system)
STEP 1. Check the steering audio switch.
Check that the radio and CD changer <vehicles without MMCS> or audio visual navigation unit <vehicles with MMCS> can be operated normally using
the steering audio switch.
Q: Is it possible to normally operate the radio and CD changer <vehicles without MMCS> or audio visual navigation unit <vehicles with MMCS>
using the steering audio switch?
YES : Go to Step 2.
NO : Diagnose the steering audio switch. Refer to <vehicles without MMCS> See: Sensors and Switches - Accessories and Optional
Equipment/Steering Mounted Controls Assembly/Testing and Inspection/Symptom Related Diagnostic Procedures/Inspection Procedure 1 or
<vehicles with MMCS>.) See: Sensors and Switches - Accessories and Optional Equipment/Steering Mounted Controls Assembly/Testing and
Inspection/Symptom Related Diagnostic Procedures/Inspection Procedure 2
STEP 2. Using scan tool MB991958, diagnose the CAN bus line.
Connect scan tool MB991958. Refer to "How to connect the Scan Tool (M.U.T.-III) ."
1. Turn the ignition switch to "ON" position.
2. Diagnose the CAN bus line.