Outlander 4WD L4-2.4L (4B12) (2008)
/Page-1031001.png)
Brake Pedal Assy: Testing and Inspection
Brake Pedal Distortion Check
BRAKE PEDAL DISTORTION CHECK
1. Place the brake pedal assembly on a level surface as shown in the figure, and set the distance from the centre of the pin assembly mounting hole to
the level surface to 97 mm (3.82 inch). Make sure that the dimension A in the figure (distance from the pedal pad surface to the level surface) is
within the standard value.
Standard value (A): 250 - 254 mm (9.8 - 10.0 inch)
2. When dimension A is not within the standard value, replace the brake pedal assembly.
