Outlander 4WD L4-2.4L (4B12) (2008)
Make mating marks on the radiator lower hose and the hose clamp. Disconnect the radiator lower hose.
INSTALLATION SERVICE POINTS
]]A[[ THERMOSTAT INSTALLATION
CAUTION: Avoid adhesion of grease to the rubber ring of the thermostat. If the rubber ring is damaged, replace the thermostat.
Install the thermostat with care to avoid peeling or damage to the rubber ring. When installing the thermostat, face the jiggle valve of the thermostat
upward.
]]B[[ RADIATOR LOWER HOSE CONNECTION
1. Insert the radiator lower hose to the projection of the water inlet fitting.
2. Align the mating marks on the radiator lower hose and hose clamp, and then connect the radiator lower hose.
REMOVAL AND INSTALLATION [3.0L ENGINE]
Pre-removal and Post-installation Operation