Outlander 4WD L4-2.4L (4B12) (2008)
[[B]] DRIVE BELT REMOVAL
To introduce the serpentine drive system with the drive belt auto-tensioner, the following operations will be required.
CAUTION: To reuse the drive belt, draw an arrow indicating the rotating direction on the back of the belt using chalk to install the same
direction.
1. Rotate the pulley bolt of the auto-tensioner counterclockwise with an offset wrench [45° a long offset wrench (5/8 x 11/16 inches) recommended]
and insert the hexagon wrench into the auto-tensioner hole to fix the auto-tensioner.
2. Remove the drive belt.
[[C]] CRANKSHAFT PULLEY CENTER BOLT/CRANKSHAFT PULLEY WASHER/CRANKSHAFT PULLEY REMOVAL
1. Hold the crankshaft drive sprocket with special tools MB990767 and MD998719.
2. Loosen the crankshaft pulley center bolt and remove the crankshaft pulley center bolt and crankshaft pulley washer.
INSTALLATION SERVICE POINTS
]]A[[ CRANKSHAFT PULLEY/CRANKSHAFT PULLEY WASHER/CRANKSHAFT PULLEY CENTER BOLT INSTALLATION