Outlander 4WD L4-2.4L (4B12) (2008)
2. Measure the resistance between joint connector (CAN2) terminal 6 and body ground.
OK: 1 kilo ohm or more
3. Measure the resistance between joint connector (CAN2) terminal 19 and body ground.
OK: 1 kilo ohm or more
Q: Do all the resistances measure 1 kilo ohm or more?
YES <vehicles with ASC> : Go to Step 2.
YES <vehicles without ASC (2WD) > : Go to Step 4.
YES <vehicles without ASC (4WD) > : Go to Step 3.
NO : Go to Step 9.
STEP 2. Check the wiring harness between joint connector (CAN2) C-04 and steering wheel sensor connector C-209 for a short to ground.
Measure the resistance at joint connector (CAN2) C-04.
CAUTION:
-
Disconnect the negative battery terminal.
-
A digital multimeter should be used.
-
The test wiring harness should be used.
1. Disconnect joint connector (CAN2), and measure the resistance at the wiring harness side of joint connector (CAN2).