Outlander 4WD L4-2.4L (4B12) (2008)
Removal Steps 1-4 (Part 2)
REMOVAL SERVICE POINT
[[A]] NEGATIVE (-) BATTERY CABLE DISCONNECTION
DANGER: Wait at least 60 seconds after disconnecting the battery cable before doing any further work.
WARNING: Battery posts, terminals and related accessories contain lead and lead compounds. WASH HANDS AFTER HANDLING.
Disconnect the negative battery cable from the battery and tape the terminal to prevent accidental connection and deployment.
[[B]] SRS-ECU REMOVAL
DANGER: The SRS-ECU adopts the rollover specification that the curtain air bag and seat belt pre-tensioner operate at the occurrence of
rollover. Therefore, do not tilt the vehicle to the right and left with the IG ON or tilt the SRS-ECU to the right and left with the IG ON and the
harness installed.
While pushing the part "A" indicated in the figure of the harness side connector, turn the lock lever to the direction of the arrow to release the lock lever.
INSTALLATION SERVICE POINTS
]]A[[ SRS-ECU INSTALLATION
WARNING: The SRS may not activate if the SRS-ECU is not installed properly, which could result in serious injury or death to the vehicle's
driver or front passenger.
]]B[[ SRS-ECU MOUNTING BOLT (GROUND BOLT) INSTALLATION