Outlander 4WD L4-2.4L (4B12) (2008)
Check the side impact sensor for dents, breakage and bending and measure the resistance between the terminals, even when installing a new side impact
sensor.
]]B[[SIDE IMPACT SENSOR INSTALLATION
WARNING: If the side impact sensor is not installed securely and correctly, the side-airbag may not operate normally. Securely connect the
connector.
]]C[[ POST-INSTALLATION INSPECTION
1. Reconnect the negative (-) battery cable.
2. Turn the ignition switch to the "ON" position.
3. Does the "SRS" warning light illuminate for approximately seven seconds, and go out?
4. If yes, the SRS system is functioning properly. If not, check chart for diagnosis codes.