Outlander 4WD L4-2.4L (4B12) (2008)
REMOVAL SERVICE POINT
[[A]] LIFTGATE WINDOW GLASS REMOVAL
Remove the liftgate window glass by the same procedure as for the windshield.
NOTE: Use a piano wire to remove the liftgate window glass.
INSTALLATION SERVICE POINTS
]]A[[ LIFTGATE DAM LOWER/LIFTGATE DAM SIDE/LIFTGATE DAM UPPER/GLASS STOPPER/FASTENER INSTALLATION
1. As shown in the figure, divide the liftgate dam lower into three pieces.
-
Liftgate dam lower center [725 mm (28.5 inches)]
-
Liftgate dam lower side (LH, RH) [471 mm (18.5 inches)]
2. By referring to the illustration, cut the end of the liftgate dam lower (liftgate dam lower center, liftgate dam lower side) and liftgate dam side.
3. Cut both ends of the liftgate dam lower center to 67°.
4. Cut both ends of the liftgate dam lower side (LH) to 30° and 67°.