Outlander AWD L4-2.4L (4B12) (2010)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
TCS or ASC
Removal and Installation
HYDRAULIC UNIT
REMOVAL AND INSTALLATION
CAUTION
When the hydraulic unit (integrated with ASC-ECU) is replaced, after turning the ignition switch ON or OFF (vehicle information from
ETACS-ECU is registered), always carry out the calibration of all sensors (steering wheel sensor, G and yaw rate sensor, and brake fluid
pressure sensor) at one time.
Pre-removal & Post-installation Operation
Removal Steps 1-12