Outlander AWD L4-2.4L (4B12) (2010)
Avoid adhesion of engine oil or grease to the O-ring.
Fit the O-ring. in the water inlet pipe groove, wet the O-ring. circumference or the pipe mounting area inner wall, and then insert the O-ring.
[B] ENGINE COOLANT TEMPERATURE SENSOR INSTALLATION
1. Apply the specified sealant to the thread of the engine coolant temperature sensor.
Specified Sealant: Three bond 1324N, Loctite 262 or equivalent
2. Use special tool MB992042 to tighten the engine coolant temperature sensor to the specified torque.
Tightening torque: 30 ± 9 Nm
[C] HOSE CLIP/RADIATOR UPPER HOSE CONNECTION
CAUTION
Never reuse the hose clip whose claw is broken off to prevent the rusting.
1. Make mating mark on a new hose clip in the same position as the remove one.