Outlander AWD L4-2.4L (4B12) (2010)
1. Make mating marks on the radiator hose and the hose clamp as shown to install them in the original position. Then, remove them.
2. Break off the tip of hose clip claw and spread out the hose clip.
NOTE: If there is a hose clip claw, the hose clip cannot spread to capacity because the claw contacts the hose clip.
3. Disconnect the radiator lower hose.
INSTALLATION SERVICE POINTS
[A] THERMOSTAT INSTALLATION
CAUTION
Avoid adhesion of grease to the rubber ring of the thermostat. If the rubber ring is damaged, replace the thermostat.
Install the thermostat with care to avoid peeling or damage to the rubber ring. When installing the thermostat, face the jiggle valve of the thermostat
upward.
[B] HOSE CLIP/RADIATOR LOWER HOSE CONNECTION
CAUTION
Never reuse the hose clip whose claw is broken off to prevent the rusting.
1. Make mating mark on a new hose clip in the same position as the remove one.