Outlander AWD L4-2.4L (4B12) (2010)
Remove the connection and clamp of heated oxygen sensor connector, and then use special tool MB991953 to remove the heated oxygen sensor.
[[B]] RIVET REMOVAL
CAUTION: Be careful not to damage the heat protector with the drill.
Use a drill [6.0 mm (0.24 inch)] to make a hole in the rivet to break it, and then remove the rivet.
INSTALLATION SERVICE POINTS
]]A[[ RIVET INSTALLATION
Use a rivet tool shown in the illustration to connect the parts with rivets by the following procedures.
1. Insert the rivet into a corresponding location.
2. Set the rivet tool at a portion A of rivet.
3. While pushing the flange surface of the rivet onto parts to be fixed with the rivet tool, press the handle of the tool.
4. Thin part of portion A of the rivet will be cut off and the part is fixed in position.