Outlander AWD L4-2.4L (4B12) (2010)
YES : Go to Step 4.
NO : Go to Step 3.
STEP 3. Check the wiring harness between foot light connector D-102 (RH), D-120 (LH) (terminal No. 1) and the fusible link (34).
Check the power supply line for open or short circuit.
NOTE: Before the wiring harness check, check the relay box connector C-308, and the intermediate connector C-35, C-32 and then repair them if
necessary.
Q: Is wiring harness between foot light connector D-102 (RH), D-120 (LH) (terminal No. 1) and the fusible link (34) in good condition?
YES : The trouble can be an intermittent malfunction.
NO : Repair the wiring harness.
STEP 4. Measure the resistance at foot light connector D-102 (RH), D-120 (LH).
1. Disconnect the connector, and measure at the wiring harness side.
2. Measure the resistance between the resistance at foot light connector D-102 (RH), D-120 (LH) (terminal No. 5) and ground.
The measured value should be continuity exists (2 ohms or less).
Q: Does the measured resistance value correspond with this range?
YES : Go to Step 6.
NO : Go to Step 5.
STEP 5. Check the wiring harness between foot light connector D-102 (RH), D-120 (LH) (terminal No. 5) and ground.
Check the ground line for open circuit.
Q: Is wiring harness between foot light connector D-102 (RH), D-120 (LH) (terminal No. 5) and ground in good condition?
YES : The trouble can be an intermittent malfunction.
NO : Repair the wiring harness.
STEP 6. Retest the system.
Check that the foot light illuminates normally.
Q: Is the check result normal?
YES : The trouble can be an intermittent malfunction.
NO : Replace the under cover rear.
Inspection Procedure 5
Inspection Procedure 5: The Interior Light Auto-cut Function Does Not Operate Correctly.