Outlander AWD L4-2.4L (4B12) (2010)
back in the connector.
Q: Is rear combination light connectors D-09 (RH) and D-14 (LH) in good condition?
YES : Go to Step 2.
NO : Repair the damaged parts
STEP 2. Resistance measurement at rear combination light connectors D-09 (RH) and D-14 (LH).
1. Disconnect the connector, and measure at the wiring harness side.
2. Measure the resistance between the connector of light which does not illuminate and body ground.
-
Measure the resistance between rear combination light connector D-09 (RH) (terminal No. 4) and body ground.
-
Measure the resistance between rear combination light connector D-14 (LH) ( terminal No. 4) and body ground.
The measured value should be continuity exists (2 ohms or less).
Q: Does the measured resistance value correspond with this range?
YES : Go to Step 4.
NO : Go to Step 3.
STEP 3. Check the wiring harness between rear combination light connectors D-09 (RH) and D-14 (LH) (terminal No. 4) and ground.
Check the ground line for open circuit.
Q: Is the check result normal?
YES : Go to Step 4.
NO : Repair the wiring harness.
STEP 4. Check ETACS-ECU connectors C-311 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is ETACS-ECU connectors C-311 in good condition?
YES : Go to Step 5.
NO : Repair the damaged parts.