Outlander AWD L4-2.4L (4B12) (2010)
1. Make mating marks on the radiator hose and the hose clamp as shown to install them in the original position. Then, remove them.
2. Break off the tip of hose clip claw and spread out the hose clip.
NOTE: If there is a hose clip claw, the hose clip cannot spread to capacity because the claw contacts the hose clip.
3. Disconnect the radiator lower hose.
[B] ENGINE COOLANT TEMPERATURE SENSOR REMOVAL
Use special tool MB992042 to remove the engine coolant temperature sensor.
INSTALLATION SERVICE POINTS
[A] O-ring INSTALLATION
CAUTION