Outlander AWD L4-2.4L (4B12) (2010)
CAN Communication Circuit (Part 2)
FUNCTION
If a short to ground is present in the CAN-C lines, this diagnosis result will be set.
TROUBLE JUDGMENT CONDITIONS
If DTC U1120 is set, the ETACS-ECU determines that there is a failure.
TROUBLESHOOTING HINTS
-
Malfunction of the connector (short to ground inside connector)
-
Malfunction of the wiring harness (short to ground in the CAN-C main or sub bus lines)
-
Malfunction of the ECU (ETACS-ECU, or ECUs on CAN-C lines failed)
DIAGNOSIS
Required Special Tools:
-
MB991223: Harness Set
-
MB992006: Extra Fine Probe
-
MB991958: Scan Tool (M.U.T.-III Sub Assembly)
-
MB991824: Vehicle Communication Interface (V.C.I.)
-
MB991827: M.U.T.-III USB Cable
-
MB991910: M.U.T.-III Main Harness A
STEP 1. Check the wiring harness between joint connector (CAN2) C-04 and ETACS-ECU connector C-301 for a short to ground. Measure the
resistance at joint connector (CAN2) C-04.
1. Disconnect joint connector (CAN2), and measure the resistance at the wiring harness side of joint connector (CAN2).