Outlander AWD L4-2.4L (4B12) (2010)
4. Measure the voltage between joint connector (CAN3) terminal 19 and body ground.
OK: 4.7 volts or less
Q: Do all the voltages measure 4.7 volts or less?
YES [CVT, A/T] : Go to Step 7.
YES [M/T] : Check intermediate connector C-33, and repair if necessary. If the intermediate connector is in good condition, repair the wiring
harness between joint connector (CAN2) C-04 and joint connector (CAN3) C-01.
NO : Go to Step 13.
STEP 7. Check the wiring harness between joint connector (CAN3) C-01 and TCM connector C-38 for a short to power supply. Measure the
voltage at joint connector (CAN3) C-01.
1. Disconnect joint connector (CAN3), and measure the voltage at the wiring harness side of joint connector (CAN3).
2. Turn the ignition switch to the ON position.
3. Measure the voltage between joint connector (CAN3) terminal 7 and body ground.
OK: 4.7 volts or less
4. Measure the voltage between joint connector (CAN3) terminal 20 and body ground.
OK: 4.7 volts or less
Q: Do all the voltages measure 4.7 volts or less?