Outlander AWD L4-2.4L (4B12) (2010)
FUNCTION
If the scan tool MB991958 cannot communicate with the TCM, this diagnosis result will be set.
TROUBLE JUDGMENT CONDITIONS
If a communication flag is not set for the TCM, the ETACS-ECU determines that there is a failure.
TROUBLESHOOTING HINTS
-
Malfunction of the connector [joint connector (CAN3) or TCM connector improperly connected]
-
Malfunction of the wiring harness [open circuit between the TCM and the joint connector (CAN3), power supply circuit to the TCM]
-
Malfunction of the TCM
DIAGNOSIS
Required Special Tools:
-
MB991223: Harness Set
-
MB992006: Extra Fine Probe
STEP 1. Check joint connector (CAN3) C-01 and TCM connector C-38 for loose, corroded or damaged terminals, or terminals pushed back in
the connector.
CAUTION: The strand end of the twisted wire should be within 10 cm (4 inches) from the connector.
Q: Are joint connector (CAN3) C-01 and TCM connector C-38 in good condition?
YES : Go to Step 2.
NO : Repair the damaged parts.
STEP 2. Check the wiring harness between joint connector (CAN3) C-01 and TCM connector C-38 for open circuit.
CAUTION: Strictly observe the specified wiring harness repair procedure.
1. Disconnect joint connector (CAN3) C-01 and TCM connector C-38, and check the wiring harness.
2. Check the wiring harness between joint connector (CAN3) C-01 (terminal No.7) and TCM connector C-38 (terminal No.4) [CVT]
OK: Continuity exists (2 ohms or less)
3. Check the wiring harness between joint connector (CAN3) C-01 (terminal No.20) and TCM connector C-38 (terminal No.5) [CVT]