Outlander AWD L4-2.4L (4B12) (2010)
FUNCTION
If the scan tool MB991958 cannot communicate with the occupant classification-ECU, this diagnosis result will be set.
TROUBLE JUDGMENT CONDITIONS
If a communication flag is not set for the occupant classification-ECU, the ETACS-ECU determines that there is a failure.
TROUBLESHOOTING HINTS
-
Malfunction of the connector [joint connector (CAN1), occupant classification-ECU connector improperly connected]
-
Malfunction of the wiring harness [open circuit between the occupant classification-ECU connector and the joint connector (CAN1), power supply
circuit to the occupant classification-ECU]
-
Malfunction of the occupant classification-ECU
DIAGNOSIS
Required Special Tools:
-
MB991223: Harness Set
-
MB992006: Extra Fine Probe
STEP 1. Check joint connector (CAN1) C-103, occupant classification-ECU connector D-34-2, front seat assembly (LH) connector D-34 and
intermediate connector C-31 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
CAUTION: The strand end of the twisted wire should be within 10 cm (4 inches) from the connector.
Q: Are joint connector (CAN1) C-103, occupant classification-ECU connector D-34-2, front seat assembly (LH) connector D-34 and intermediate
connector C-31 in good condition?
YES : Go to Step 2.
NO : Repair the damaged parts.
STEP 2. Check the wiring harness between joint connector (CAN1) C-103 and occupant classification-ECU connector D-34-2 for open circuit.
CAUTION: Strictly observe the specified wiring harness repair procedure.
1. Disconnect joint connector (CAN1) C-103 and occupant classification-ECU connector D-34-2, and check the wiring harness.
2. Check the wiring harness between joint connector (CAN1) C-103 (terminal No.11) and occupant classification-ECU connector D-34-2 (terminal
No.24)
OK: Continuity exists (2 ohms or less)