Outlander AWD L4-2.4L (4B12) (2010)
CAUTION: To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or
disconnecting scan tool MB991958.
1. Connect scan tool MB991958. Refer to "How to connect the Scan Tool (M.U.T.-III)." See: Reading and Clearing Diagnostic Trouble Codes/How
to Connect the Scan Tool (M.U.T.-III)
2. Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
3. Check if DTC is set.
4. Turn the ignition switch to the "LOCK" (OFF) position.
Q: Is the DTC set?
YES: Troubleshoot the ETACS-ECU. See: Testing and Inspection/Diagnostic Trouble Code Descriptions/ETACS
NO: Go to Step 2.
STEP 2.Column switch check
-
Check the continuity for windshield wiper and windshield washer switch. See: Testing and Inspection/Diagnostic Trouble Code
Descriptions/Column Switch
-
Check the continuity for column switch (switch body part). See: Testing and Inspection/Diagnostic Trouble Code Descriptions/Column Switch
Q: Is the check result normal?
YES: The trouble can be an intermittent malfunction
NO: Replace the column switch.