Outlander AWD L4-2.4L (4B12) (2010)
Q: Is ignition switch connector C-210 in good condition?
YES : Go to Step 2.
NO : Repair the defective connector.
STEP 2.Check the battery power supply circuit to the ignition switch. Measure the voltage at ignition switch connector C-210.
1. Disconnect the connector, and measure at the wiring harness side.
2. Measure the voltage between terminal 1 and ground.
-
The voltage should measure approximately 12 volts (battery positive voltage).
Q: Is the measured voltage approximately 12 volts (battery positive voltage)?
YES : Go to Step 6.
NO : Go to Step 3.
STEP 3.Check the fuse No.14.Q: Is the check result normal?
YES : Go to Step 4.
NO : Replace the fuse No.14.(Check that there is not a short to ground in the circuit of lower reaches before replacing. If there are any problems,
replace the fuse after the circuit of lower reaches is repaired.)
STEP 4.Check ETACS-ECU connector C-317 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is ETACS-ECU connector C-317 in good condition?
YES : Go to Step 5.
NO : Repair the damaged parts.
STEP 5.Check the Wiring harness between ignition switch connector C-210 (terminal No.1) and ETACS-ECU connector C-317 (terminal No.3).
-
Check the battery power supply line for open circuit.
Q: Is the check result normal?
YES : Go to Step 7.
NO : Repair the wiring harness.
STEP 6. Check the ignition switch.
Remove the ignition switch. Then check continuity between the switch terminal.