Outlander AWD L4-2.4L (4B12) (2010)
1. Remove the clip (for securing the floor carpet), and turn back the floor carpet.
2. Remove the clip (for securing the steering shaft cover), and then remove the steering shaft cover.
[C] STEERING COLUMN SHAFT ASSEMBLY REMOVAL
1. Remove the steering column bolt connecting the steering gear to the steering column assembly.
2. Disconnect the steering gear from the steering column assembly while sliding the shaft to the shaft B with the clip claw as shown in the figure is
pinched.
3. Remove the steering column mounting bolt.
INSTALLATION SERVICE POINTS
[A] STEERING COLUMN SHAFT ASSEMBLY INSTALLATION
1. Ensure that the tilt lever is in the lock position.
2. Temporarily tighten the mounting bolts in the order of a, b, and c, and then tighten them in the order of c, b, and a to the specified torque.
Tightening torque a: 28 ± 7 Nm (21 ± 5 ft-lb)