Outlander AWD L4-2.4L (4B12) (2010)
Disconnect the steering gear and linkage assembly from the steering column shaft assembly while sliding the shaft A to the shaft B with the clip claw
as shown in the figure is pinched.
[B] SELF-LOCK NUT (TIE-ROD END AND KNUCKLE CONNECTION) REMOVAL
CAUTION
^
Loosen the self-locking nut from the ball joint, but do not remove here. Use the special tool.
^
To prevent the special tool from dropping off, suspend it with a cord.
1. Install the special tool MB991897or MB992011 as shown in the figure.
2. Turn the bolt and knob to make the special tool jaws parallel, then hand-tighten the bolt. After tightening, check that the jaws are still parallel.
NOTE: To adjust the special tool jaws to be parallel, set the knob as shown in the figure so that it functions as a fulcrum of the jaws.
3. Turn the bolt and disconnect the tie-rod end from the steering knuckle.
[C] FRONT AXLE CROSSMEMBER ASSEMBLY REMOVAL