Outlander AWD L4-2.4L (4B12) (2010)
Wheel Bearing: Testing and Inspection
Front Axle
WHEEL BEARING END PLAY CHECK
1. Remove the front caliper assembly and front brake disc, and retain the front caliper assembly with a wire and the like to prevent from falling.
2. Set a dial gauge as shown in the figure. Move the hub in the axial direction and measure the end play.
Limit: 0.05 mm (0.002 inch)
3. If the play exceeds the limit, disassemble hub knuckle to check each component. If the front hub bearing is faulty, replace it.
4. After checking, install the front brake disc and the front caliper assembly.
HUB BOLT REPLACEMENT
Required Special Tools:
^
MB990767: Front Hub and Flange Yoke Holder
^
MB991618: Hub Bolt Remover
1. Remove the front caliper assembly and front brake disc, and retain the front caliper assembly with a wire and the like to prevent from falling.
2. Use special tool MB991618 to remove the hub bolts.
3. Install the plain washer to the new hub bolt, and install the bolt with a nut while holding the hub with special tool MB990767.
4. Install the front brake disc and the front caliper assembly.