Outlander AWD L4-2.4L (4B12) (2010)
Fluid - Transfer Case: Service and Repair
Transfer Oil Replacement
CVT
TRANSFER OIL REPLACEMENT [AWD]
1. Remove the drain plug and gasket, and gasket to drain the transfer oil.
2. Install the drain plug and new gasket, and new gasket, then tighten them to the specified torque.
Tightening torque: 32 ± 2 Nm (24 ± 1 ft-lb)
3. Remove the filler plug and gasket, then fill the oil up to the lower edge of the filler plug hole.
Brand name: Hypoid gear oil API classification GL-5 SAE80 or 90
Filling amount: 0.54 dm3 (0.57 qt)
4. Install the filler plug and new gasket, then tighten them to the specified torque.
Tightening torque: 32 ±2 Nm (24 ±1 ft-lb)
CVT CONTROL COMPONENT CHECK
ACCELERATOR PEDAL POSITION SENSOR (APS) CHECK
Refer to Troubleshooting See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code
Descriptions/Multiport Fuel Injection (MFI).
TRANSMISSION RANGE SWITCH CHECK
See: Transmission Control Systems/Testing and Inspection/Component Tests and General Diagnostics/Continuously Variable Transaxle
(CVT)/Transmission Range Switch Continuity Check.
STOPLIGHT SWITCH CHECK
Refer to Brake Pedal See: Lighting and Horns/Brake Light Switch/Testing and Inspection.
F6AJA/W6AJA
TRANSFER OIL REPLACEMENT