Outlander AWD L4-2.4L (4B12) (2010)
NOTE: Use a piano wire to remove the liftgate window glass.
INSTALLATION SERVICE POINTS
>>A<< LIFTGATE DAM LOWER/LIFTGATE DAM SIDE/LIFTGATE DAM UPPER/GLASS STOPPER/FASTENER INSTALLATION
1. As shown in the figure, divide the liftgate dam lower into three pieces.
-
Liftgate dam lower center [725 mm (28.5 inches)]
-
Liftgate dam lower side (LH, RH) [471 mm (18.5 inches)]
2. By referring to the illustration, cut the end of the liftgate dam lower (liftgate dam lower center, liftgate dam lower side) and liftgate dam side.
3. Cut both ends of the liftgate dam lower center to 67°.
4. Cut both ends of the liftgate dam lower side (LH) to 30° and 67°.
5. Cut both ends of the liftgate dam lower side (RH) to 67° and 30°.
6. Cut one side of the liftgate dam side (LH) end to 62°.