Outlander AWD L4-2.4L (4B12) (2010)
4. Using glass adhesive knife
Keep glass adhesive knife at right angles with the windshield edge, and put the blade at windshield edge and surface. Then cut away adhesive
along the windshield edge.
5. Use special tool MB990480 to remove the windshield.
CAUTION:
-
Be careful not to remove more adhesive than is necessary.
-
Be careful also not to damage the paint on the body surface with the knife. If the paint is damaged, repair the damaged area with
touch-up paint.
6. Use a knife to cut away the remaining adhesive so that the thickness is within 2 mm (0.08 inch) around the entire circumference of the body flange.
7. Finish the flange surfaces so that they are smooth.
CAUTION: Allow the cleaned area to dry for at least three minutes. Do not touch any surface that has been cleaned.
8. When reusing the windshield, remove the adhesive still adhering to the windshield, and clean with 3M(TM) AAD Part No. 8906 or equivalent
9. Clean the body side in the same way.
INSTALLATION SERVICE POINTS
>>A<< WINDSHIELD SPACER/GLASS STOPPER/WINDSHIELD MOLDING INSTALLATION
CAUTION: Leave the degreased parts for 3 or more minutes to dry well, before starting on the next step. Do not touch the degreased parts.