Outlander AWD L4-2.4L SOHC (2003)
Wheel Speed Sensor: Testing and Inspection
ABS SENSOR OUTPUT VOLTAGE MEASUREMENT
Required Special Tool:
MB991219: Inspection Harness
1. Lift up the vehicle and release the parking brake.
2. Disconnect the ABS-ECU connector B-03, and then use special tool MB991219 to measure the output voltage at the harness side connector.
3. Manually turn the wheel to be measured 1/2 to 1 turn/second. Measure the output voltage with a voltmeter or oscilloscope.
Output voltage:
^
Minimal voltmeter reading: 42 mV
^
Maximum voltmeter reading: 300 mV
^
Minimal oscilloscope reading: 120 mV
^
Maximum oscilloscope reading: 600 mV
Probable causes of low output voltage
^
ABS sensor pole piece-to-ABS rotor clearance too large
^
Faulty ABS sensor
NOTE: Check the connection of the sensor harness and connector before using the oscilloscope.