Outlander AWD L4-2.4L SOHC (2003)
CAUTION: Do not remove the tape securing the crank shaft position sensor connector and control wiring harness, since the control wire ring
harness may contact the power steering oil pump pulley.
<<B>> VALVE TIMING BELT REMOVAL
CAUTION: Never turn the crankshaft anticlockwise.
1. Turn the crankshaft clockwise, align each timing mark to set No. 1 cylinder to TDC of its compression stroke.
2. Remove the timing belt under cover rubber plug and then set the special tool MD998738.
3. Screw in the special tool MD998738 until it comes in contact with the timing belt tensioner arm.
CAUTION: The adjusting bolt special tool (MD998738) can be gradually installed at a rate of a 30 degree turn per second. If it is screwed
