mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Diagram Information and Instructions|Page 5719 > < Diagram Information and Instructions|Page 5717
Page 1
background image

Cargo Lamp: Description and Operation

DOME LIGHT

With the dome light switch in the "door controlled operation" (middle) position, the ETACS-ECU controls the dome light operation as follows:

-

When a door is opened from outside or inside [with the ignition switch turned to "LOCK" (OFF)]:

-

When a door is opened, the ETACS-ECU causes the dome light to be illuminated at 100% intensity. When the door is closed, it dims the dome
light to 65% intensity and approximately 30 seconds later, turns out the light completely. During this period (timer controlled period), the dome
light goes out if the ignition switch is turned "ON" or the doors are locked.

-

When a door is opened or closed with the ignition switch in the "ON" position: The dome light illuminates at 100% intensity when a door is
opened and turned out when it is closed.

-

When no door is opened and the ignition key is removed: The dome light is illuminated at 100% intensity and turned off approximately 30
seconds
 later. During that time (timer-controlled period), the dome light goes out if the ignition key is inserted and turned to "ON" or the door
locking system is activated.

-

Dome light's answer back operation in response to door lock control by keyless entry system: To allow the driver to confirm the doors have locked
by the keyless entry system, the ETACS-ECU causes the dome light to blink twice when the doors are locked by the RKE system and to illuminate
for approximately 15 seconds when the doors are locked. The dome light's answer back operation in response to a keyless entry system control
action is accompanied by flashing of the hazard warning lights.

Interior light automatic shutoff function

Operation of interior light automatic shutoff function

This function prevents the battery from being discharged when the door is open or the dome light remains on with the ignition switch at the "LOCK"
(OFF) position. The ETACS-ECU turns on its "keep" relay to switch off the battery power supply to the interior lights when the interior light loaded
signal and all door switches remain on for approximately 30 minutes with the ignition switch at positions other than ACC. Then the interior lights will be
switched off. If the ignition switch is turned on again, the ETACS-ECU turns on its "keep" relay to illuminate the interior lights.

Dome light control function

GENERAL DESCRIPTION CONCERNING INTERIOR LIGHT

When the dome light switch is at the door position, the ETACS-ECU controls the lighting of the dome light as follows:

-

When a door is opened to get on or get off the vehicle with the ignition switch off, the dome light lights up at a luminance of 100 percent. When a
door is closed, the dome light dims at a luminance of 65 percent, and goes off 30 seconds later. However if the ignition switch is turned ON or if

Diagram Information and Instructions|Page 5719 > < Diagram Information and Instructions|Page 5717