Outlander AWD L4-2.4L SOHC (2003)
Turn Signal Bulb: Service and Repair
Rear Position
Position Light Bulb
1. Screw out the position light socket.
2. Disconnect the connector.
CAUTION: As a principal, the position light can be removed as individual part. If not, remove the position light from the headlight and position light
assembly, and then remove the position light from the headlight. Then replace the bulb.
Do not touch the bulb surface bare-handed or with dirty gloves. If dirt is attached on surface of the bulb, immediately use alcohol or thinner
to remove dirt, and install the bulb after well dried.
