Outlander AWD L4-2.4L SOHC (2003)
2. Measure the voltage between terminal 5 and ground.
-
The voltage should equal approximately 12 volts (battery positive voltage).
Q: Is the measured voltage approximately 12 volts (battery positive voltage)?
YES: Go to Step 35.
NO: Go to Step 33.
STEP 33. Check power window relay connector C-208 and rear power window sub-switch (RH) connector E-19 for loose, corroded or
damaged terminals, or terminals pushed back in the connector.
Q: Are power window relay connector C-208 and rear power window sub-switch (RH) connector E-19 in good condition?
YES: Go to Step 34.
NO: Repair or replace the damaged components). Refer to Harness Connector Inspection. The rear power window (RH) function should work now
normally.
STEP 34. Check the wiring harness between power window relay connector C-208 (terminal 4) and rear power window sub switch (RH)
connector E-19 (terminal 5).
