Outlander AWD L4-2.4L SOHC (2003)
YES: Replace the power window main switch. The rear power window (RH) function should work now normally.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. The rear power window (RH) function should work now normally.
STEP 38. Check the ground circuit to the rear power window sub-switch (RH). Test at rear power window sub-switch (RH) connector E-19.
1. Disconnect rear power window sub-switch (RH) connector E-19 and measure the resistance available at the harness side of the connector.
2. Measure the resistance value between terminal 8 and ground.
-
The resistance should equal 2 ohms or less.
Q: Is the measured resistance 2 ohms or less?
YES: Go to Step 41.
NO: Go to Step 39.
STEP 39. Check power window main switch connector E-04 and rear power window sub-switch (RH) connector E-19 for loose, corroded or
damaged terminals, or terminals pushed back in the connector.
