Outlander AWD L4-2.4L SOHC (2003)
2. Measure the voltage between terminal 9 and ground.
-
The voltage should equal approximately 12 volts (battery positive voltage).
Q: Is the measured voltage approximately 12 volts (battery positive voltage)?
YES: Replace the front-ECU. Verify that the headlights (low-beam) illuminate normally.
NO: Go to Step 4.
STEP 4. Check the front-ECU connector A-11X for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is the front-ECU connector A-11X in good condition?
YES: Go to Step 5.
NO: Repair or replace the damaged components). Refer to Harness Connector Inspection. Verify that the headlights (low-beam) illuminate normally.
STEP 5. Check the wiring harness between front-ECU connector A-11X (terminal 9) and the battery.