Outlander AWD L4-2.4L SOHC (2003)
2. Measure the resistance value between terminal 3 and ground.
-
The resistance should equal 2 ohms or less.
Q: Is the measured resistance 2 ohms or less?
YES: Go to Step 31.
NO: Go to Step 29.
STEP 29. Check rear combination light (RH) connector D-13 for loose, corroded or damaged terminals, or terminals pushed back in the
connector.
Q: Is rear combination light (RH) connector D-13 in good condition?
YES: Go to Step 30.
NO: Repair or replace the damaged components). Refer to Harness Connector Inspection. Verify that the taillight (RH) illuminate normally.
STEP 30. Check the wiring harness between rear combination light (RH) connector D-13 (terminal 3) and ground.
Q: Is the wiring harness between rear combination light (RH) connector D-13 (terminal 3) and ground in good condition?
YES: Replace the rear combination light socket (RH). Verify that the taillight (RH) illuminate normally.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that the taillight (RH) illuminate normally.
