Outlander AWD L4-2.4L SOHC (2003)
If the high-beam indicator light does not illuminate, the high-beam indicator light bulb or the ETACS-ECU may be defective.
TROUBLESHOOTING HINTS
-
The high-beam indicator light bulb may be defective
-
The ETACS-ECU may be defective
-
The wiring harness or connectors may have loose, corroded, or damaged terminals, or terminals pushed back in the connector
Required Special Tool:
-
MB991223: Harness Set
STEP 1. Verify the headlight operation.
Q: Do the headlights illuminate?
YES: Go to Step 2.
NO: Repair the headlights first.
STEP 2. Check at ETACS-ECU connector C-219 in order to check the high-beam indicator light circuit.
1. Disconnect ETACS-ECU connector C-219, and measure at the wiring harness side.
2. Turn the ignition switch to the "ON" position.
3. Connect terminal 72 to ground.
Q: Does the high-beam indicator light illuminate?