Outlander AWD L4-2.4L SOHC (2003)
NOTE: Also check junction block connector C-202 and intermediate connector C-116 for loose, corroded, or damaged terminals, or terminals pushed
back in the connector. If junction block connector C-202 or intermediate connector C-116 is damaged, repair or replace the damaged
component(s) as described in Harness Connector Inspection.
Q: Is the wiring harness between front combination light (RH) connector A-28 (terminal 2) and ETACS-ECU connector C-217 (terminal 9) in good
condition?
YES: Replace the socket. Verify that the turn-signal lights illuminate normally.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that the turn-signal lights illuminate normally.
STEP 21. Check the side turn-signal light bulb (LH).
1. Remove the side turn-signal light (LH) bulb.