Outlander AWD L4-2.4L SOHC (2003)
NOTE: Also check joint connector C-02 and intermediate connector C-105 for loose, corroded, or damaged terminals, or terminals pushed back in the
connector. If joint connector C-02 or intermediate connector C-105 is damaged, repair or replace the damaged component(s) as described in
Harness Connector Inspection.
Q: Is the wiring harness between park/neutral position switch connector B-21 (terminal 7) and ETACS-ECU connector C-220 (terminal 39) in good
condition?
YES: Replace the ETACS-ECU. If the rear wiper operates normally, it indicates that a correct "R" position signal is sent from the park/neutral
position switch.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. If the rear wiper operates normally, it indicates that a correct "R" position signal is sent from the
park/neutral position switch.
Inspection Procedure N-5
The ETACS-ECU does not receive any signal from the driver's or the front passenger's door switch.