Outlander AWD L4-2.4L SOHC (2003)
Q: Is the wiring harness between hazard warning light switch connector C-21 (terminal 1) and ETACS-ECU connector C-219 (terminal 55) in good
condition?
YES: Replace the ETACS-ECU. If the equipment, which are described in "CIRCUIT OPERATION", work normally, the input signal from the hazard
warning light switch should be normal.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. If the equipment, which are described in "CIRCUIT OPERATION", work normally, the input
signal from the hazard warning light switch should be normal.
Inspection Procedure O-3
The ETACS-ECU does not receive any signal from the driver's seat belt switch.