Outlander AWD L4-2.4L SOHC (2003)
Required Special Tool:
MB991502: Scan Tool (MUT-II)
REMOVAL SERVICE POINTS
[[A]] NEGATIVE (-) BATTERY CABLE DISCONNECTION
DANGER:
Wait at least 60 seconds after disconnecting the battery cable before doing any further work.
WARNING: Battery posts, terminals and related accessories contain lead and lead compounds. WASH HANDS AFTER HANDLING.
Disconnect the negative (-) battery cable from the battery and tape the terminal to prevent accidental connection and seat belt pre-tensioner operation.
[[B]]PRE-TENSIONER CONNECTOR DISCONNECTION
1. Use a flat-tipped screwdriver to pull out forward and unlock the locking button of the harness-side connector.
2. Disconnect the pretensioner connector.
INSTALLATION SERVICE POINTS
]]A[[ PRE-INSTALLATION INSPECTION
WARNING: Dispose of seat belt pre-tensioner only according to the specified procedure.
1. When installing the new seat belt pre-tensioner, refer to "INSPECTION".
2. Connect the negative (-) battery cable.
CAUTION: To prevent damage to scan tool MB991502, always turn the ignition, switch to the "LOCK" (OFF) position before connecting or
disconnecting scan tool MB991502.