Outlander AWD L4-2.4L SOHC (2003)
CAUTION: Be careful when pressing the journal bearings. If they are pressed at an angle, the inside of the journal bearings will be
damaged.
2. Use Special Tool MB990840 to press the journal bearing into the center yoke until the snap ring groove is fully visible.
3. Use Special Tool MB990840 to press the opposite side journal bearing into the yoke.
4. Align the mating marks on the center yoke and rear propeller shaft, and install the propeller shaft journal bearings in the same manner as
described in (1) and (2) above.
>>G<< SNAP RING INSTALLATION
1. Install a snap ring to one side of the journal.
2. Use Special Tool MB990840 at the opposite side of the installed snap ring to press in the journal bearing toward the snap ring.
CAUTION: Always use snap rings of equal thickness on both sides.
34 ± 5 Nm (25 ± 4 ft. lbs.) 34 ± 5 Nm (25 ± 4 ft. lbs.)
3. Install the snap ring on the opposite side, and measure the clearance of the snap ring groove with a feeler gauge.
Standard value (A): 0.02 - 0.06 mm (0.001 - 0.002 inch) or less