Precis L4-1468cc 1.5L SOHC (1993)
Cause
The driven bevel gear is too separated from the drive bevel gear.
Remedy
Use thinner driven bevel gear mount adjusting spacer to bring the driven bevel gear more closer to the drive bevel gear.
NOTE:
(1) If correct tooth contact cannot be obtained even by change of the driven bevel gear mount adjusting spacer, increase or decrease or decrease
the drive bevel gear preload adjusting spacer and the drive bevel gear mount adjusting spacer as described below and then adjust tooth contact
again.
-
When the driven bevel gear height is too small even it the thinnest driven bevel gear mount adjusting spacer 0.13 mm (.0051 in.) is used:
Replace the drive bevel gear mount adjusting spacer that is in use with one that is one rank thicker and replace the drive bevel preload
adjusting spacer that is in use with one that is one rank thinner.
-
When the driven bevel gear height is too large even if the thickest driven bevel gear mount adjusting spacer 0.52 mm (.025 in.) is used:
Replace the drive bevel gear mount adjusting spacer that is in use with one that is one rank thinner and replace the drive bevel gear preload
adjusting spacer that is in use with one that is one rank thicker.
(2) Repeat above steps until the tooth contact pattern equal or close to the standard pattern is obtained.
(3) If the tooth contact pattern cannot be adjusted close to the standard pattern by above adjustment, replace the drive bevel gear and driven bevel
gear as a set and readjust the tooth contact.
Extension Housing
EXTENSION HOUSING (4WD)
