Raider V6-3.7L SOHC (2006)
Wheel Speed Sensor: Service and Repair
Rear
SENSOR - WHEEL SPEED - REAR
REMOVAL
1. Raise vehicle on hoist.
2. Remove brake line mounting nut (4) and remove the brake line (3) from the sensor stud.
3. Remove the park brake cable (2) and bracket (1) from the sensor stud.
4. Disconnect the electrical connector (6).
5. Remove mounting stud (2) from the sensor (5).
6. Remove sensor (1) from differential housing (3).
INSTALLATION
1. Connect harness to sensor (1). Be sure seal is securely in place between sensor and wiring connector.
2. Install O-ring on sensor (if removed).