Raider V6-3.7L SOHC (2006)
Enter this campaign claim over the MDL using the Recall claim type option. Sample claim screens are shown.
Use Campaign Labor Operation C0603TXX.
Labor Time: 0.3 hours
There are no allowable parts for this recall campaign.
IF AN ABORTED OR CORRUPTED FLASH OCCURRED DURING THIS PROCEDURE:
CCNs are not stocked items at MMNA PDCs. CCNs are exchange items only and must be ordered from RSSC (Radio Sales & Service Corporation)
located in Houston, Texas.
Refer to the RSSC order procedures on page 12 of the Raider LOTS manual.
^
Call RSSC.
^
Visit the RSSC website (and CCN order website).
Required Operations
REQUIRED OPERATIONS
Before starting this campaign procedure, CHECK ON THE WARRANTY SUPERSCREEN to verify that the vehicle is an affected VIN for this
campaign and that this campaign procedure has not already been completed.
CAUTION
DO NOT DISTURB THE HARNESS CABLES OR CONNECTIONS. THE CCN MODULE MUST BE REPLACED IF AN ABORTED OR
CORRUPTED FLASH OCCURS.
CAUTION
BATTERY VOLTAGE (AS MEASURED AT THE BATTERY POSTS WITHOUT ELECTRICAL LOAD) MUST BE 12.4V OR HIGHER IN
ORDER TO REPROGRAM THE CCN.
The following equipment is needed to reprogram the CCN for this concern:
^
MUT-III STV 13.1 / RAIDER STV 2.2 Upgrade and RAIDER V6 A/T Reflash Update CD 5/06 or later
^
VCI (Vehicle Communication Interface) - MB991824
^
MUT-III main harness A (blue) - MB991910
^
USB 2.0 cable - MB991827
^
"Engine Compartment/Control Module" labels - p/n MSSF-024G-00
1.
Check the underside of the hood to verify that there is no label previously installed to indicate that this campaign reprogramming has already been
done.
