Raider 2WD V6-3.7L (2008)
Seat Heater Control Module: Service and Repair
SWITCH/MODULE - HEATED SEAT
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Using an appropriate flat bladed tool, remove the heated seat switch/modules from the console by gently prying up from the top edge of the
switch/module bezel. Take care not to scratch or damage the console or bezel in any way.
3. Disconnect the switch/module electrical connectors (2) and (4).
4. Using an appropriate flat bladed tool, remove the heated seat switch/module (3) from the bezel (1).
INSTALLATION