Raider 2WD V6-3.7L (2008)
Ambient Temperature Sensor / Switch HVAC: Service and Repair
Sensor - Ambient Air Temperature (Message Systems)
SENSOR - AMBIENT AIR TEMPERATURE - REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Locate the ambient temperature sensor (1), on the left side of the radiator yoke (2) behind the grille.
3. Disconnect the wire harness connector (3) from the ambient temperature sensor connector receptacle.
4. Remove the one screw that secures the ambient temperature sensor bracket to the radiator yoke.
5. Remove the ambient temperature sensor from the radiator yoke.
INSTALLATION
1. Position the ambient temperature sensor (1) onto the radiator yoke (2).
2. Install the screw that secures the ambient temperature sensor to the radiator yoke. Tighten the screw to 5.5 N.m (50 in. lbs.).
3. Connect the wire harness connector (3) to the ambient temperature sensor (1).
4. Reconnect the battery negative cable.
