Raider 2WD V6-3.7L (2008)
Blower Motor Relay: Service and Repair
RELAY - BLOWER MOTOR
REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Open the cover of the integrated power module (IPM) (1) located in the engine compartment.
NOTE: Refer to the fuse and relay layout map on the IPM cover for blower motor relay identification and location.
3. Remove the blower motor relay (2) from the IPM.
INSTALLATION
NOTE: Refer to the fuse and relay layout map on the integrated power module (IPM) cover for blower motor relay identification and location.
1. Position the blower motor relay (2) into the proper receptacle of the IPM (1).
2. Align the blower motor relay terminals with the terminal cavities in the IPM receptacle and push down firmly on the relay until the terminals are
fully seated.
3. Close the cover of the IPM.
4. Reconnect the negative battery cable.