Raider 2WD V6-3.7L (2008)
Seat Belt Height Adjuster: Service and Repair
ADJUSTER - SEAT BELT TURNING LOOP
REMOVAL
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor.
Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is
integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Mitsubishi Parts Catalog.
NOTE: A seat belt turning loop adjuster is used for both front outboard seating positions on all vehicles; however, the following procedure applies only
to the B-pillar mounted adjuster used on double cabs. The telescoping roof rail mounted adjuster used on extened cabs is integral to the front outboard
seat belt and retractor assembly.
1. Unsnap the upper edge of the trim cover (1) from the front seat belt turning loop (2) and disengage the tab (3) on the lower edge of the cover to
access the turning loop screw.
