Raider 2WD V6-3.7L (2008)
8. Remove and inspect the upper and lower spring isolators.
INSTALLATION
1. Install the lower isolator.
2. Install the upper isolator.
3. Position the shock into the coil spring.
4. Install the upper shock mounting plate.
5. Install shock nut wrench 9362 (2) (on end of a torque wrench), on shock shaft retaining nut. Next, insert 8 mm socket though Wrench onto hex
located on end of shock shaft. While holding shock shaft from turning, tighten nut using Wrench to 45 Nm (33 ft. lbs.) torque.
6. Install the shock upper mounting nut.